Cable Routing to Wescott Modular Roof Rack

Wirenut386

New member
Joined
Apr 12, 2025
Messages
1
Reaction score
0
So I have the ORP and pre-ordered Wescott's Modular Roof Rack about a month ago. There is a good handful of things I am considering mounting on the rack, but unsure how to cleanly accommodate the mass of wires it's likely to generate.

Things getting installed on rack
  1. Front light bar
  2. left lights, right lights, and rear lights (would like independently switched)
  3. Starlink
  4. Solar Panel - maybe...
  5. Dual band VHF/UHF Anteanna (RG59)
  6. Other misc stuff not requiring power.
So, I've seen for a single power run it can get tucked along the windshield with minimal visibility, but with this many wires how should I accomplish this? I am not opposed to drilling, but I want to make sure it will last and not leak/cause issues down the line.

Any advice is helpful.
 
I bought their low profile roof rack and molle pannel. both excellent quality. i have no wiring plans, but did have other questions and the guys at Wescott were very responsive. just call them or text them with your questions. they also have a ton of install videos they can probably direct you to.
 
I usually run two sets of wires down the windshield for big cable runs. One of the drivers side and one on the passenger side.

I use KC wire hiders. They're big enough for one 4 gauge wire or 2-3 12 gauge wires. I would assume that 2-3 12 gauge wires on each side of the windshield would be plenty to support what you're trying to accomplish without drilling.

 

New Threads

Ok guys, making the plunge on a plate system...
I came across this 6th Gen 4Runner on...

Recent

If you want a FREE 6G4R.com decal, comment below with "6G4R.com Decal". That's it. Each free...
I was just at X Overland’s Ranch, and Goose Gear was there showcasing their product on the new...
I’ve secured first allocation rights for a TRD Pro in Mudbath. Wanted to make sure the vehicle...
Ok guys, making the plunge on a plate system for the cargo area on the TRD OR Hybrid. I just...
just got my TRD Pro last week - love it
After putting 1500 hard miles on the 2025 6th Gen 4Runner, I wanted to give an honest breakdown...
I came across this 6th Gen 4Runner on Instagram and my gosh does this vehicle looks so good in...
Installed NYTOP rock sliders on TRD Pro
I purchased some Toyota OEM rock rails for my 6 Gen Off Road and the OEM instructions stated to...
So I'm at about 2600 miles now on my new 6th Gen, and I was wondering if you all are planning to...
I'm looking to dip my toe in to a wheel upgrade but the first think I am interested in doing is...
Back
Top