Lock Off-Road Invader Forged Beadlocks & 35" Arroyo MT Tires

[Trail4R]

Finally!!! They landed. We have a set of Lock Off-Road Invader Forged Beadlocks in machine finish with some 35" Arroyo M/Ts.

Beyond stoked to get these wheels mounted and finally get the 4Runner off the ground a little bit.

 

[Golden Vista]

Nice! Post some pictures once these badboys are mounted and if possible, try to measure your MPG before and after.
Those look pretty sweet, congrats!

 

[Trail4R]

Thanks, man. This is how it sat on 35" tires with a +25mm offset and no lift. It was rubbing pretty bad on the inner fender well near the rocker panel and front bumper. To run it like this, I would’ve needed to trim at least 1" of sheet metal near the rocker panel and up into the fender flares. The front bumper would also have required a 1" trim, and the fender liner would need to be pushed forward and re-mounted to the bumper. I’m still waiting on my Peak lift kit - 2.25" up front and 2" in the rear - with upper control arms for some improved caster. I decided to wait on the kit instead of trimming to revaulate exactly how much trimming will be required - if any.

 

[Trail4R]

It only took me about 5 hours to get these mounted but damn was it worth the process.

These wheels are beautiful!! Can't wait to get these mounted.

 

[Golden Vista]

That looks sick.
Are you going to get some mudflaps to protect your paint from the tires kicking up debris?

 

[Trail4R]

@Golden Vista for now, probably just some PPF along the rocker panel. I think a 6-8" strip along the rocker would suffice until companies start making an entire PPF strip for the cutout body lines that follow both doors into the rear fenders. I think Lamin-X is usually one of the first to come out with kits like this but still haven't seen them release anything.

 

[Trail4R]

Here's how it's sitting after the Peak Collar lift.

2025+ Toyota 4Runner 2-Piece Collar Lift – 2.25″ Lift Kit

https://www.peaksuspension.com/product/2025-toyota-4runner-2-piece-collar-kit-2-25-lift/

Clearance is much better than before. Still required trimming on the front bumper and on the sheet metal near the rocker panel - but it was minimal compared to what we were looking at before.

 

[Trail4R]

And finally some sunset shots of the 4Runner after the Peak lift kit, 35" Arroyo MTs, and 17x9" +25mm offset.

 

[4RunnerNation]

Daaaaaaayum!!!! This thing is looking amazing. Well done. Stoked to see the portals go on.

 

[rustytaco]

Those wheels go so hard! Saw them in person, there's a ton of detail on these.